WARNING! Before attempting any of the following operations, make
sure that the tool is switched off and unplugged and that the saw
blade has stopped. Used saw blades may be hot.
FITTING AND REMOVING THE SAW BLADE
Loosen (do not remove) the two screws.
01
Hold the saw blade with the teeth
02
facing forward (PIC 1).
Insert the shank of the saw blade into
03
the blade holder as far as it will go.
ADJUSTING THE SHOE PLATE
FOR BEVEL CUTS
The shoe plate (4) can be set to make
either a straight cut or a bevel cut at an
angle of 45°.
ASSEMBLY
04
alternately to position the blade, then fully
tighten the two screws (PIC 2).
05
screws (6) one turn counter-clockwise.
PIC 1
INSTRUCTION FOR USE
01
02
the shoe plate reaches the 45° position
(PIC 4). Tighten the screw.
PIC 3
Slightly tighten the two screws
To remove the saw blade, turn both
Loosen the screw (PIC 3).
rotate the shoe plate until the slot in
PIC 2
PIC 4
21