Troubleshooting; Fasteners - Husky HD219000 Manual De Instrucciones

Fasteners

HD219000 Tool will also drive fasteners designed for: Campbell Hausfeld NS219000, Sears 18465, Porter Cable FR350, Hitachi
NR83A, and Senco FramePro 702XP, 752XP, Ridgid R350RHA, and DeWalt D51844, D51845.
HD289000 Tool will also drive fasteners designed for: Campbell Hausfeld NS289100, Sears 18420, Atro Helen 90CH, and Bostitch
F28WW, N100S, N865, N805, N16.
HD349000 Tool will also drive fasteners designed for: Campbell Hausfeld NS349000, Porter Cable FC 350A, Hitachi NR83AA2,
Senco FramePro 701XP, 751XP , Ridgid R350CHA, DeWalt D51822, D51823, and Paslode F-3505.
Troubleshooting Guide
Authorized Service Center.
Problem
Air leaking at trigger valve
Air leaking between
housing and nose
Air leaking between
housing and cap
Nailer skips driving nail
Nailer runs slow or has loss
of power
Nails are jammed in nailer
Stop using nailer immediately if any of the following problems occur. Serious personal injury
could result. Any repairs or replacements must be done by a Qualified Service Person or
Cause
O-Rings in trigger valve housing are
damaged
Loose screws in housing
Damaged O-Rings
Damage to bumper
Loose screws
Damaged gasket
Worn bumper
Dirt in nose piece
Dirt or damage prevent nails or pusher
from moving freely in magazine
Damaged pusher spring
Inadequate air flow to nailer
Worn O-Ring on piston or lack of
lubrication
Damaged O-Ring on trigger valve
Air leaks
Cap gasket leaking
Nailer not lubricated sufficiently
Broken spring in cylinder cap
Exhaust port in cap is blocked
Guide on driver is worn
Nails are not correct size
Nails are bent
Magazine or nose screws are loose
Driver is damaged
Models HD219000, HD289000, & HD349000
Solution
Replace O-Rings. Check operation of Work
Contact Element (WCE)
Tighten screws
Replace O-Rings
Replace bumper
Tighten screws
Replace gasket
Replace bumper
Clean drive channel
Clean magazine
Replace spring
Check fitting, hose or compressor
Replace and lubricate O-Rings
Replace O-Rings
Tighten screws and fittings
Replace gasket
Lubricate nailer
Replace spring
Replace damaged internal parts
Replace guide
Use only recommended nails
Replace with undamaged nails
Tighten screws
Replace driver
7