STORAGE FEATURES
CAUTION
To avoid personal injury or property
damage, handle tempered glass
shelves carefully. Shelves may break
suddenly if nicked, scratched, or
exposed to sudden temperature
change. Allow the glass shelves to
stabilize to room temperature before
cleaning. Do not wash in dishwasher.
NOTE
Features may vary according to model.
You can easily adjust shelf positions in
the fresh food compartments to suit
your needs. The shelves have mounting
brackets that attach to slotted supports
at the rear of each compartment.
Change the Position of a Shelf
1 Remove all food from shelf.
2 Lift the front edge up and pull the
shelf out.
3 Replace by inserting the mounting
bracket hooks into the desired
support slots.
4 Lower the shelf and lock into position.
IMPORTANT
Be aware of the air seal located at the
rear of the shelf. Shelves located on
the left side should have the air seal
mounted on the far left side. Shelves
located on the right side should have
the air seal mounted on the far right
side. This is to ensure there is no
interference with the large air tower on
the back wall of the cabinet. This also
applies to the crisper shelves.
24
Flip Shelf
Reposition the Air Seal
For crisper shelves:
1 Remove air seal by pushing down on
the flap with a downward rotation.
2 Position the air seal towards the
outside end of the shelf to avoid the
air tower when shelf is pushed back
into place.
3 Install seal by sliding lower tab of seal
up into bottom rear slot of shelf with
seal at a downward angle then pulling
up on seal flap until seal sits snug on
back of shelf and flap sits at about a
10 degree angle from shelf surface.
For glass shelves:
1 Remove air seal by pushing seal
straight back.
2 Position the air seal towards the
outside edge of the shelf to avoid the
air tower when shelf is pushed back
into place.
3 Install seal by sliding the open
channel end of the seal onto back
edge of shelf until seal sits snug on
back of shelf and flap sits at about a
10 degree angle from shelf surface.
EN