Philips X-tremeUltinon LED-HL[≈H1] Manual Del Usuario página 4

• The LED-HL [≈H1] lamp has a relatively
high temperature; do not let it get close
to flammable materials or parts.
• For the best heat-sink effects, do not
wrap the control box completely with
tape or sponge.
m Warnings
• When working, the LED-HL [≈H1] lamp
and the LED drive box will be at a very
high temperature. Do not touch them
directly with fingers or skin,
to avoid scalding.
4
• The LED illumination of the LED-HL
[≈H1] lamp is of high intensity; do not
look directly at the LED-HL [≈H1] lamp,
to avoid eye damage.
• Before you remove the halogen H1
lamp, make sure that the lamp's
temperature has dropped to room
temperature, to avoid burning fingers
or skin.
• Do not let the LED-HL [≈H1] lamp be-
come exposed to dust, grease or stains,
or scratch the surface of the LED; this
will damage the LED-HL [≈H1] lamp.
• Do not let children touch the LED-HL
[≈H1] product.
m Other Information
• Please make sure that you purchase the
Philips LED-HL [≈H1] lamp through the
correct channels.
• After the lamp is installed, please
check if the light pattern is okay, and
make sure that the indicators on the
dash board are working normally and
that nothing is abnormal.
• After the lamp is installed, please
check whether the air-tight cover is
properly sealed to avoid undesirable
sealing; and whether the control box
and the wiring harness are firmly in
place, and not interfering with other
parts inside the lamp or the fan above
the lamp.