Maintenance And Cleaning - Abicor Binzel ABITIG WH 220WS Folleto De Instructiones

Ocultar thumbs Ver también para ABITIG WH 220WS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

®
ABITIG
WH
Equipping the welding torch
 Abb. / Fig. 2 on page -1
In place of an electrode holder (4), you can use a gas diffuser, which, based on its design,
generates a laminar gas flow.
You must perform steps 1 and 2 only if you use the torch with the TES torch exchange station.
NOTICE
• Ensure that wear parts specific to the welding torch are correctly assigned.
1 Push the sensor ring (6) with the flat side up from the front as far as it will go (8) over the
torch body (9) (optional).
2 Tighten the cylinder head screws M3 × 10 (10) and fix the sensor ring (6) on the
torch body (9) (optional).
3 Push the insulator (5) from the front onto the torch body (9).
4 Insert the electrode holder (4) from the front into the torch body (9).
5 Insert the tungsten electrode (3) from the front into the electrode holder (4).
6 Hold the tungsten electrode (3) and the electrode holder (4) and tighten the clamping
element (7) with the torque wrench.
 Tab. 2 Tightening torques on page EN-3
7 Screw the gas nozzle (1) onto the torch body (9).
®
ABITIG
®
ABITIG
®
ABITIG
Tab. 2

Maintenance and cleaning

Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free
operation.
NOTICE
• Clean the welding torch during each welding break if there is heavy weld spatter.
1 Clean the joints.
2 Lubricate the O-rings lightly with a silicone-free grease.
3 Check the wear parts for visible damage and replace them, if necessary.
 Tab. 2 Tightening torques on page EN-3
BEI.0121.0 • 2020-02-14
WH 220WS
WH 400WS
WH 400WSK
Tightening torques
Max. 1 Nm
Max. 1.5 Nm
Max. 1.5 Nm
EN - 3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Abitig wh 400wsAbitig wh 400wsk

Tabla de contenido