Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ABOUT THE CODES
F
– The F code means your unit is empty and needs to be FILLED with water.
CL
– Your CONTROLS ARE LOCKED on the current setting. Activate the control lock by holding the power button for five
seconds, until CL appears. Your Tower will lock on the current fan and humidity settings. Release the lock by pressing the
power button again for five seconds until the display flashes CL three times, letting you know the lock is off.
CF
– The CF code triggers after 720 hours of use and means it's time to CHECK YOUR FILTER (wick). Unplug your unit and
check your wicks. If your wicks are still in good shape, simply clear the code by plugging your humidifier back in. If your wicks
need replacing, follow these quick steps:
1.
Remove the water bottles, then remove the front and back grilles. Do not discard your grilles.
2.
Remove your old wicks and replace them with two new 1040 Super Wicks®.
3.
Replace the grilles, then reattach your water bottles.
8
Plug in your unit and set your desired fan
speed by pressing the fan button
Your Tower has four fan speeds that are displayed
by F1 (the lowest speed) through F4 (the highest
speed). F0 indicates your Tower is in standby
mode.
9
Press the humidity control button
to set your humidity level from 25% to
65%. The humidistat on your cord will read your
home's humidity and turn your fan off when the
set level is reached. When set to 65%, your unit
will run continuously.
That's it! Your Tower is ready to use.
.
Publicidad
Tabla de contenido
