Publicidad
Idiomas disponibles
Idiomas disponibles
(05)How to use Electronic Torque Adapter
A Battery Install and Replacement. (see under point (11) Torque Range too)
1. CR2032x 1pc.
2. Keep the end thread clean and dry for a good contact.
3. Open the battery cap.
4. Remove the old battery.
5. Install 1 pc CR2032 battery in the Electronic torque adapter (with the "+") sign facing
upwards).
6. Screw the battery cap.
Note
1. When battery are low
2. Remove the battery if stored for a long period of time.
3. Battery life depends on battery quality and the amount of the lights and buzzer are used.
4. Typical life is up to 55 hours.
(06)How to use Electronic Torque Adapter
B Power On.
1. Press
button and hold for 3 seconds to turn Torque Adapter on. The LCD
panel shows
2. After 2 seconds the LCD panel shows "00.0".
3. Swing the digital adapter.
4. The LCD displays the torque value measured.
Note
lf you do not use the wrench for 80 seconds the Torque Adapter will automatically shut off.
C How to select "Unit".
Press "+" and "-" button together and release to select different torque units.
Note
1. When you change units the target setting will also be changed to the new units value.
2. This digital torque adapter contains 5 unit selections. (kg-cm, kg-m, in-lb, ft-lb, N-m).
(07) How to use Electronic Torque Adapter
D How to select "Target Torque Value".
1. Increase (+):
1. Press and hold the (+) button to increase the current target value,
2. The target will show for 10 seconds.
3. After 10 seconds the LCD display 0.00.
2. Lower (-):
1. Press and hold the (-) button to lower the current target value,
2. The target will show for 10 seconds.
3. After 10 seconds the LCD display 0.00.
Note
1. When you are approaching -20% unit Before the target you will see a flash of green light
and hear an intermittent buzzer Warring you that you are approaching the torque value.
2. When you are target value you will see a flash of red light and hear buzzer. Stop pulling.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
icon will light.
.
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Publicidad
