Publicidad
Idiomas disponibles
Idiomas disponibles
3. When the torque strength is 20% higher than target setting which will appear flashing
orange light and intermittent buzzer for a warning.
(08) How to use Electronic Torque Adapter
E How to set "peak" or "Trace".
PEAK :
1. Press
and
button at the same time and release to set the PEAK when Electronic
Torque Adaptor is on.
2. The L.C.D panel shows
3. The L.C.D panel shows "00.0" and shows "Peak" on the bottom left corner after 2
seconds.
TRACE :
1. Press
and
button at teh same time and release to set TRACE when Electronic
Torque Adaptor is on.
2. The L.C.D panel shows
3. The L.C.D panel shows" 00.0" and shows "Trace" on the bottom left corner after 2
seconds.
F How to use backlight
Press backlight button to turn on the display backlight at inadequate light place and and
press button again to turn off the backlight
G Turn Off.
1.If you do not use the Electronic Torque Adaptor for 80 seconds the digital torque adaptor
will automatically shut off.
2. To manually turn off the Electronic Torque Adaptor press about 3 seconds the
button.
(09) How to use Electronic Torque Adaptor
H Memory
1. Store reading must be under the "Ptop" mode.
2. Press "Mem" button at least 1 second and release.
3. The display show the memory number is "P01" than "Torque Value".
4. Press "Mem" button at least 1 second one more time.
5. The display show the memory number is "P02" than "Torque Value".
6. 50 sets Revolving storage memory available
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
.
.
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Publicidad
