Troubleshooting - Omega Lift Equipment 44915 Manual Del Usuario

3. Fill with oil until just below the rim of the oil filler hole. Reinstall the oil filler plug.
4. Perform Bleeding/Venting Trapped Air procedure (page 3).
Lubrication
1. A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that
pump assemblies move freely.
2. For air option model 44981C: When used on a daily basis, air pump should be internally lubricated before each
use. Use a good quality air tool lubricant. If no in-line oiler is used, pour a teaspoon of air tool oil into the inlet of
the air control valve. Simply operate the jack using the air feature in order to fully distribute the oil.
Cleaning
Periodically check the pump piston and ram plunger for signs of rust or corrosion. Clean as needed and wipe with
an oily cloth.
NOTICE: Never use sandpaper or abrasive material on ram or pump piston surfaces.
Storage
When not in use, store the jack with pump piston and ram plunger fully retracted and air supply disconnected.

TROUBLESHOOTING

Symptom
Jack will not lift load
Jack will lift, but not maintain
pressure
Jack will not lower after
unloading
Poor lift performance
Will not lift to full extension
Possible Causes
• Release valve not tightly closed
• Load is too heavy
• Air pressure inadequate
• Release valve not tightly closed
• Hydraulic unit malfunction
• Reservoir overfilled
• Fluid level low
• Air trapped in system
• Fluid level low
5
Corrective Action
• Ensure release valve tightly closed
• Consider higher capacity jack
• Ensure adequate air pressure
• Ensure release valve tightly closed
• Contact Omega Tech. Service
• Ensure load is removed, then drain
fluid to proper level
• Ensure proper fluid level
• Perform Bleeding/Venting
Trapped Air procedure (page 3)
• Ensure proper fluid level