Description Of The Machine - Proxxon LWS Manual Del Usario

Translation of the
Original Operating Instructions
Dear Customer!
Please read the enclosed safety regulations and
operating instructions before using the unit.
Key
1. Locking button
2. ON-OFF switch
3. Unit handle
4. Connection cable with mains plug
5. Protective guard
6. Grinding disc

Description of the machine:

The PROXXON long neck angle grinder LWS is the
ideal device for model making, tool making and mould
making and is also suitable, for example, for vehicle
repairs.
It can be used for deburring, roughening, fine grin-
ding, chamfering, paint removal, rust removal, cutting
small components and sharpening tools.
It can be used on steel, non-ferrous metals, glass,
wood and ceramics.
Flat gearhead manufactured from die cast aluminium.
Technical Data
Motor:
Voltage
Output power
Unit:
Rotational speed
Disc diameter
Length
Weight
Generated noise
Vibration at the handle
For use in dry environments only
Protection class II device
Please do not dispose
off the machine!
- 6 -
220-240 V, 50/60 Hz
100 Watt
13000 rpm
50 mm
250 mm
approx. 700 g
≤ 78 dB (A)
≤ 2.5 m/s 2
Operation
Replacing the Grinding Disc
Important!
Disconnect the plug from the mains before repla-
cing the grinding disc.
The grinding disc diameter must not exceed the
specified size.
Note:
Only use accessories and spare parts recommen-
ded by PROXXON (observe max. permissible
speed).
Never press the locking button if the grinding disc
is still rotating.
1. Press the locking button 1 (Fig. 2).
2. Turn the fastening screw 4 using an Allen key 5
until the locking button engages.
3. Undo the fastening screw 4, remove the centring
disc 3 and the grinding disc 2.
4. Fit a new grinding disc.
Ensure the grinding disc is properly seated in the
centring disc shoulder.
5. Press the locking button 1 and tighten the fa-
stening screw 4.
Adjust the protective guard.
IMPORTANT!
Disconnect the plug from the mains before the follo-
wing.
1. Release fastening screw 1 (Fig. 3) and turn the
protective guard to the desired position.
2. Retighten the fastening screw.
Ensure the grinding disc is properly seated in the
centring disc shoulder.