Using Control Lever; Important Notes - Mettler Toledo PJA334 Manual De Usuario

5 Lift the forks until the pallet and load are entirely off the ground (refer to [Using Control Lever Page 9]
for instructions on lifting). Make sure there's no peripheral items or obstacles touching the pallet, the forks,
or the load.
6 Read the weight value when the reading on the weighing terminal gets stable.

5.2.3 Using Control Lever

To Lower Forks
1 Set the control lever in the LOWER position.
2 The forks will drop to the lowest position.
To Lift Load
1 Set the control lever in the ASCENT position.
2 Push the lowered forks into the pallet.
For safety reasons, place the load centrally across
the forks and not at the end of the forks.
3 Pump the handle to lift the load.
To Move Pallet Truck Scale
1 Set the control lever in the NEUTRAL position.
2 Pull the handle to move the scale.

5.2.4 Important Notes

For best weighing results observe the following:
To achieve best weighing results, ensure the center of
gravity of the load between folks.
Ensure the load is lifted freely without touching the
housing of the terminal or other pallets.
Place the load from the root of forks. Do not place the
load at the end of forks.
Pallet Truck Scale
WARNING:
Operation​ ​ 9