Assembly And Operation - Worx A XIS WX550L Manual Del Usuario

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
Working mode adjustment
Position I worked as a jigsaw.
Position II worked as a reciprocating saw.
NOTE: Select the blade best suitable
for the working mode for better cutting
performance (special reciprocating
saw blade not included).
WARNING!
• To avoid being pinched, keep
hands away from the hinge when
changing positions.
• To avoid tool being turned on
accidentally, make sure keep your
hands away from the lock-off button.
• Before operation, make sure the pivot
12
release button is locked into position.
ASSEMBLY
Replacing the saw blade
When using jig saw mode, the blade
teeth face outward as shown in Fig. D1;
while in rep saw mode, the blade teeth
should face as shown in Fig. D3.
CAUTION: Keep your
hands away from the lock-off
button to prevent switch actuation
before making any adjustments or
removing or installing attachments or
accessories.
OPERATION
WARNING! Burn hazard. Do not touch the
blade immediately after use. Contact with the
blade may result in personal injury.
Switching On and Off
NOTE: For safety reasons the On/
Off switch of the machine cannot be
locked; it must remain pressed during
the entire operation.
Pendulum Function
Multi-Purpose Saw
Cutting
WARNING!
• Never hold the pivot head when
operating the tool.
• Never hold the motor cover when
operating the tool.
Always use a blade suited to the
material and material thickness to be
cut. Before cutting any type of material,
FIGURE
be sure it is firmly anchored or
clamped to prevent slipping. Holding
the work by hand or against your body
See Fig. A1
leaves it unstable and may lead to loss
of control.
See Fig. A2
• Whenever possible, the saw foot
See Fig. A3
plate must be held firmly against the
material being cut. This will prevent
the saw from jumping or vibrating and
minimize blade breakage.
LED Work Light
WORKING HINTS FOR YOUR
See Fig. B1
- C3
MULTI-PURPOSED SAW
If your power tool becomes too hot, run no-load for 2-3
minutes to cool the motor. Avoid prolonged usage at
very low speeds.
Any movement of the material may affect the quality of
the cut. The blade cuts on the upward stroke and may
chip the uppermost surface.
Ensure your uppermost surface is a non-visible surface
when your work is finished.
MAINTENANCE
See Fig. D1
Your power tool requires no additional
- D3
lubrication or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
See Fig. E
See Fig.
F1, F2
See Fig.
G1-G3
See Fig. H
EN