Kohler K-T10302 Guia De Instalacion página 9

Thermostatic
Valve
Screw
Escutcheon
4. Install the Trim - K-T10422
Firmly press the valve stem adapters onto each of the valve
stems.
Secure the valve stem adapters to the valve stem with the correct
length screws, as selected in the "Install the Valve Stem Adapters"
section of this guide.
Thread the two threaded studs into the threaded holes of the
valve.
Place the front plate assembly over the threaded studs.
NOTE: If the front plate assembly does not lay flat on the wall
surface, loosen the nuts and adjust the threaded studs, then
re-tighten the nuts. The maximum distance between the threaded
studs from the wall is 7/16" (1.11 cm).
Inspect the front seal plate assembly to ensure that the foam seal
is completely covering the wall opening. If not, stop the
installation and repair the wall opening.
Place the escutcheon against the wall. The drain hole in the
escutcheon should face downward in the 6 o'clock position.
Thread the adapter rings onto the hub of the front plate assembly.
Place the handle assemblies against the escutcheon by lining up
the pins in the handle assembly with the holes in the escutcheon.
Make sure the setscrew holes are facing down.
Kohler Co.
Volume Control
Valve Stem Adapter
Screw
Threaded Studs
Front Plate Assembly
Adapter Ring
Nuts
Setscrews
9
Handle
Assembly
1041504-2-E