Using Your Control(S); Setting The Dual Remotes; Step-By-Step; Important - Sunbeam Bedding Manual De Usuario

Using your Remote Control(s):
1 To turn the warming blanket/mattress pad ON, simply press the
"On/Off" button. The backlit display light will illuminate and begin to
warm at the comfort setting last used.
CAUTION: ALWAYS turn the warming blanket/mattress pad "Off"
when not in use.
2 To turn the warming blanket/mattress pad OFF simply press the
"On/Off".

Step-by-step

1 Place the warming blanket/mattress pad on the bed with the label at the
foot of the bed facing outward (see diagram, page 4).
2 Make sure the base unit cord is connected into the module at the bottom of
the warming blanket/mattress pad until the plastic hinges click into place.
CAUTION: Cord must be COMPLETELY CONNECTED. A risk of fire could
result from a loose connection.
3 Run the base unit cord on the floor under the bed. Do not sandwich cord
between the mattress and box spring. Avoid any tangling or pinching.
4 Place the base unit on the floor under the bed.
5 Place the remote control(s) where it is convenient for you.
6 Plug power cord into a 110-120 volt wall outlet.
*Please see page 6 if you have more than one Sunbeam Remote Control Warming Product.
Dual operation settings:
Each person can have complete control over his/her comfort level for ultimate personalized warmth.
The "left" control operates the left side.
Either "left" or "right" control can be set to operate the entire blanket/mattress pad.
• Locate the dual control setting switch (on back of each control, above battery panel).
• Set switch to preferred operating setting – Both sides or one side only
2
The "right" control operates the right side.
CAUTION: Do not plug main
power cord into the wall
outlet until you have
completely set up your
warming product per the
instructions.
• Disconnect power cord
from wall before detaching control from warming
product.
• Always make sure cords are NOT trapped or pinched
between bed slats, mattress, springs, against wall,
foot board or bed frame, or between furniture, walls
or chairs.
CAUTION: Do not attempt to force the plug. This
appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electrical shock, this
plug is intended to fit only one way into an outlet. If the
plug does not fit in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician.

IMPORTANT

5