Heat Surge Fireless Flame Manual Del Usuario página 3

DO NOT modify this heating unit. Use it only as described in this manual. any other
use not recommended by the manufacturer may cause fire, electrical shock or injury.
The output air may vary in temperature. at times the air may become intense enough
to burn exposed skin. Use of this heating unit is not recommended for persons with
reduced sensitivity to heat or an inability to react to avoid burns.
DO NOT burn wood or other materials in this fireplace.
DO NOT strike fireplace glass.
when transporting or storing the fireplace and cord, keep in a dry place, free from
excessive vibration and store so as to avoid damage.
This heater has a self-protection function. if the heater does not operate normally, to
reset the heater, unplug the power cord from outlet for 15 minutes. Then plug the
power cord back in for reuse of the heater. Connect to properly grounded outlets only.
SAVE ThESE INSTRUCTIONS.
SET UP
Place the heating unit on a firm, level surface free of obstructions and at least 3 ft.
(0.9 m) away from any combustible materials. DO NOT use on an unstable surface
such as bedding or deep carpeting.
OPERATION
This section will explain the function of each convenient control.
INSTRUCTIONS
CONNECT TO 3-PRONG OUTLET ONLy. This heater is for use on 120 volts. The cord has
a 3-prong plug as shown in figure A. if you have a 2-slot outlet as shown in figure B, please DO
NOT use a 2-slot to 3-prong adapter plug as shown in figure D. Have a licensed electrician
replace your 2-slot outlet with a 3-prong grounded outlet shown in figure C. Or, replace it with
a 3-prong Ground Fault Circuit interrupter (GFCi) with the label "no equipment Ground" as
shown in figure E. DO NOT PLUG INTO LOOSE fITTING OUTLET. DO NOT ATTEmPT
TO mODIfy ThIS PLUG OR DEfEAT ThIS SAfETy fEATURE IN ANy WAy.
figure A
fireplace 3-Prong
Plug head
Grounding Pin
The heater may emit a slight, harmless odor when first used. This odor is a normal condition
caused by initial heating of internal heater parts and will not occur again.
mAIN fIREPLACE CONTROL PANEL
The fireplace main power control is located on the upper right hand corner of the glass
front.
mAIN POWER/ON: The fireplace main power is on when it is plugged into the 3-prong
outlet/receptacle. Power is provided to the touch fireplace control panel on the upper right
hand of glass front. The thermostat display will show the current room temperature. Fireplace
will return to factory default settings if unplugged or if power supply is interrupted.
NO
figure b
DO NOT use 2-slot
Outlet with No hole
for Grounding Pin
figure D
DO NOT use a
2-slot to 3-Prong
adapter
YES
figure C
Use 3-Prong
Grounded Outlet
figure E
Use 3-Prong Ground fault Circuit
Interrupter (GfCI) Outlet with Label
"NO EQUIPmENT GROUND."
2