Heat Surge Fireless Flame Manual Del Usuario página 4

TOUCh fIREPLACE CONTROL PANEL
The Touch Fireplace Control Panel is located on the front upper right hand corner of the glass front.
To locate the Touch Fireplace Control Panel refer to Figure F.
(FiGUre F)
D
A – ON/Off bUTTON: The fireplace on/off touch button supplies the main power to the fireplace.
b – SLEEP TImER bUTTON: The Sleep Timer automatically shuts off the fireplace heat
at a preset time. There are five settings: 2 hours, 4 hours, 6 hours, 8 hours and no time
limit for continuous operation. The fireplace heat will automatically turn off when the timer
completes time limit setting. The Sleep Timer can be canceled at any time by pressing the
SleeP TiMer BUTTOn repeatedly until the sleep timer displays "0" or off.
C – hEATER hIGh/LOW/fAN/Off mODE bUTTON: The heater High/low/Fan/Off
button is used to cycle through the heat mode settings. There are four settings: Flame
Only, High Heat, low Heat and Fan with no heat.
D – ThERmOSTAT bUTTONS:
DIGITAL ThERmOSTAT: Your heater is equipped with a Digital Thermostat that
allows you to set your heater to your precise comfort level.
SETTING ThE DIGITAL ThERmOSTAT:
1. in both the High and low Heat modes you may press the up or down buttons to
reach your desired temperature.
2. Once you have reached your desired temperature, the display will return to current room
temperature and gradually increase until the room has reached the preset temperature.
3. if the unit will not start in the digital thermostat mode*, please make sure the "set
temperature" is higher than the current room temperature. *default temperature setting is 80°.
NOTE: it is normal for the heater to cycle On and OFF as it maintains the preset
temperature. To prevent the unit from cycling, you need to raise the thermostat
setting. when the preset temperature is reached, the fan will run for 60 seconds
without heat. This cool down process ensures an accurate and consistent
temperature reading. if you unplug the heater, you will have to reset the digital
thermostat again by following the above instructions.
REmOTE CONTROL (optional product offering)
OPERATION, bUTTONS AND INDICATORS
On the first usage of the remote control, remove the battery tab. The receiver for the
b
D
E
3
F
(FAN
D C
NO HEAT)
remote control is mounted behind the touch fireplace
control panel.
A. POWER: Turns the unit On and Off
A
b. TImER hOURS: automatically shuts off the Fireplace
heat at a preset time. There are five settings: 2 hours, 4 hours,
6 hours, 8 hours and no time limit for continuous operation.
The fireplace heat will automatically turn off when the timer
completes time limit setting. The timer can be cancelled at any
time by pressing the Timer Hours button repeatedly until the
C
sleep timer displays turn off.
C. hEAT hIGh/LOW/fAN/Off: is used to cycle through the
heat mode setting. There are four settings: Flame Only, High
Heat, low Heat and Fan with no heat. To cycle through the 4
settings press the button to go to the next heat setting.
D. TEmPERATURE SETTINGS UP: is used to turn up the
H
L
(HEAT
B
HIGH, LOW)
2 8
4 6
(TIMER
A
HOURS)