Baby Lock Ellegante 3 BLG3 Guía De Referencia Rápida página 24

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note
• The bobbin case (gray) cannot be used for sewing in
any way other than bobbin work. After sewing
bobbin work, refer back to the steps in "Preparing
the Bobbin Thread" for removing and cleaning the
bobbin case (gray), and then reinstall the standard
bobbin case (black).
• Be sure to use the bobbin case (gray) when creating
bobbin work. Using any other bobbin case may
result in the thread becoming tangled or damage to
the machine.
• Make sure that the bobbin case is correctly
installed. If the bobbin case is incorrectly installed,
the thread may become tangled or the machine may
be damaged.
h
Install the needle plate cover.
For details on installing the needle plate cover,
refer to the machine's Instruction and Reference
Guide.
a
Needle plate cover
• When creating bobbin work, use the bobbin cover
with tabs (for bobbin work), otherwise the thread
may become tangled or the needle may break.
i
Install the flat bed attachment.
j
Insert the thread tail from the spool of thread
through the hole in the bobbin from the inside
to the outside. Hold the thread tail while
winding the thread around the bobbin by
hand. After winding the bobbin so it is filled
as shown below (about 80%), cut the thread.
22
CAUTION
CAUTION
CAUTION
• Be sure to use the machine's included bobbin or one
designed specifically for this machine (Class 15).
Using any other bobbin may result in damage or
injuries.
11.5 mm
(approx.
7/16 inch)
This model
Note
• Slowly and evenly wind the thread around the
bobbin.
• For best results, wind the bobbin so the thread is
snug and not twisted.
k
Using scissors carefully trim the thread tail as
close to the bobbin as possible.
a
Beginning of wound thread
CAUTION
• If thread extends beyond the top of the bobbin too
much, the thread may become tangled or the
needle may break.
Memo
If inserting thread tail through bobbin hole is difficult
bobbin can be wound by holding tail and wrapping
thread around inside base. Then carefully trim thread
tail so it does not extend from the side of the bobbin.
l
Install the bobbin wound with thread.
Whether or not tension should be applied to the
bobbin thread depends on the type of thread
being used.
Actual size
Other models

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido