Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
How to use & charge
Please charge the product fully before
the first operation.
Caution
When charging the battery, the button
on the main unit and the remote control
will not work.
Only use authorized adapter. Or, it may
cause serious damage to the product.
1 Wet mops thoroughly with
clean water, then wring water
out.
* We recommend you wash the
mops with detergent before
first time use.
4 Close the rubber cap of the
water supply mop kit and
attach to the bottom of the
main unit. (Pressing down
while gently turning side to
side. You will hear a click when
they attach.)
VR6000TM_QG_Mopping-Robot_NA_EN.indd 5
Yellow LED Blinks
Low battery level
2 Attach the mop pads to the
water supply mop kit. (See
the figure below.)
Correct
Wrong
5 Press the Operation button
for 2 seconds until it beeps
and light stays on, and then
start cleaning.
Blue LED Blinks
Medium battery level
3 Open the rubber cap of the
water supply mop kit and fill
it with clean water.
* Using the product without
water in the water supply
mop kit may cause static
electricity.
* Water only.
Correct
6 After using, pour out any
remaining water from the
water supply mop kit.
LED is OFF
Full battery
Wrong
5
2020-04-14
12:31:58
Publicidad
Tabla de contenido
