Publicidad
Idiomas disponibles
Idiomas disponibles
5. Never reach around saw blade.
6. Turn off tool and wait for saw blade to stop before moving workpiece or changing settings.
7. Disconnect power before changing blade or servicing.
8. To reduce risk of injury, return carriage to the full rear position after each crosscut operation.
9. Return all guards to original position if any are moved during blade replacement. Check all guards for
proper operation after service.
10. The lock down pin is to be used only to lock the head in place for carrying and storage. It is not to be
used for any cutting operation.
11.
DANGER! Coasting Cutting Tool Can Be Dangerous – Apply brake immediately to stop cutting
tool when the switch is turned off.
12. The torque developed during braking may loosen the blade-retaining nut/bolt. The blade retaining
nut/bolt should be checked periodically and tightened if necessary, especially after braking.
13. Always use blades with correct size and shape (diamond versus round) of arbor holes. Blades that
do not match the mounting hardware of the saw will run eccentrically, causing loss of control.
14. Never use damaged or incorrect blade washers or bolt. The blade washers and bolt were specially
designed for your saw, for optimum performance and safety of operation.
15. Do not use to cut logs, tree limbs, or uneven lumber.
16. Wet lumber, green (unseasoned) lumber, and pressure treated lumber all have an increased potential
for kickback and should only be cut with a blade for cutting that lumber type. Wear a approved respirator
and have appropriate ventilation whenever cutting pressure treated lumber.
17. Do not use blades made from high-speed steel, abrasive blades, metal-cutting blades or masonrycut-
ting blades. The guards of this saw are not designed to protect against the failure of such blades.
18. Blades must be rated to at least the maximum speed marked on the tool.
19. DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED. Moving guards
must move freely and close instantly.
20. The use of accessories or attachments not recommended by the manufacturer may result in a risk of
injury to persons.
21. When servicing use only identical replacement parts.
4
www.ELITETOOLS.co
Keep Working
Publicidad
