Pantalla Sata Settings (Configuración De Sata) - Dell PowerEdge R530xd Manual Del Propietário

Menu Item
Logical Processor Idling
Configurable TDP
X2Apic Mode
Number of Cores per
Processor
Processor 64-bit Support
Processor Core Speed
Processor Bus Speed
Processor 1
Family-Model-Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Pantalla SATA Settings (Configuración de SATA)
Puede utilizar la pantalla SATA Settings (Configuración SATA) para ver la configuración SATA de
dispositivos SATA en el sistema.
Para ver la pantalla SATA Settings (Configuración de SATA), haga clic en System Setup Main Menu
(Menú principal de configuración del sistema) → System BIOS (BIOS del sistema) → SATA Settings
(Configuración SATA).
Elemento del menú
SATA incorporado
Security Freeze Lock
Caché de escritura
32
Description
Enables or disables the operating system capability to put logical
processors in the idling state in order to reduce power consumption. By
default, the option is set to Disabled.
Allows reconfiguration of Thermal Design Power (TDP) to lower levels.
TDP refers to the maximum amount of power the cooling system is
required to dissipate.
Enables or disables the X2Apic mode.
Controls the number of enabled cores in each processor. By default, the
Number of Cores per Processor option is set to All.
Specifies if the processor(s) support 64-bit extensions.
Displays the maximum core frequency of the processor.
Displays the bus speed of the processor.
NOTA: The processor bus speed option displays only when both
processors are installed.
NOTA: Depending on the number of installed CPUs, there may be
up to two processor listings. The following settings are displayed for
each processor installed in the system.
Displays the family, model and stepping of the processor as defined by
Intel.
Displays the brand name reported by the processor.
Displays the total L2 cache.
Displays the total L3 cache.
Displays the number of cores per processor.
Descripción
Permite establecer el SATA incorporado en los modos Off
(Deshabilitado) ATA o AHCI. De manera predeterminada, la opción
Embedded SATA (SATA incorporado) está establecida en AHCI.
Envía el comando para el bloqueo de cierre de seguridad de unidades
SATA incorporadas durante la autoprueba de encendido (POST). Esta
opción solo es aplicable al modo AHCI y ATA.
Activa o desactiva el comando para unidades SATA incorporadas durante
la autoprueba de encendido (POST).