Fixings; Completing Assembly; Assembly Of The Counterweight (Optional) (Fig.9); Important - Incold ROLL UP-ZIP Manual De Uso Y Mantenimiento

3.3.4 Fixings

VERSION 590 mm
Use the 3 metal M12 bars for the upper securing; secure from the inner side with a flat washer plus a
spring washer and its cap nut (Fig. 6
VERSION 420 mm
For securing at the top, use the two nylon tie rods with their washers and allocated nuts from the opposite
part of the securing wall. (Fig. 6 version
Proceed with inserting the nylon tie rods and from the opposite part place the nylon washer and its nut
on all the slotted holes (Fig. 6).

3.3.5 Completing assembly

Assemble the two aluminium side covers. It is not necessary to use screws for securing the covers in the
standard version (first) because they snap in. For the stainless steel version, use the screws provided.
VERSION 590 mm
Assemble the two side brackets supporting them on the bearing brackets; assemble the other brackets
at the same height (only for large size doors) (Fig. 7).
Insert the sheet hinges inside the side housings in the upright for at least 20 cm delicately pulling
downwards. (Fig. 7).
Assemble the casing: secure it to the wall supporting it on the previously assembled brackets (Fig. 8).
VERSION 420 mm
Insert the sheet hinges inside the side housings in the upright for at least 20 cm delicately pulling
downwards. (Fig. 7).
Assemble the casing: rest it and secure it to the previously assembled door crosspiece with suitable
screws. (Fig. 8).

3.3.6 Assembly of the counterweight (OPTIONAL) (Fig.9)

IMPORTANT: The counterweight can only be mounted on prepared doors, as the type of
motor used releases the brake in the event of a power failure, allowing the weight to open
the door.
• Proceed with mounting of the counterweight only after having adjusted the limit switches.
• Open the door completely then lower it slightly until the counterweight belt is completely unwound.
• In this position, fix the counterweight at approximately 15 cm from the ground. Ascertain, by removing
tension, if the weight is sufficient for reopening. If the counterweight is insufficient, add one or two
weights. Check that during opening and closing,the counterweight touches neither the floor nor the
upper roller. If it does, raise or lower the position of the counterweight on the belt.
• Fix the side casing and the upper casing to the panel with self-drilling screws.
10
version 590 mm).
420 mm)