Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND ASSEMBLY INSTRUCTIONS
WLS | WLM | WLL Series
IMPORTANT: READ BEFORE REMOVING FIXTURE FROM CARTON.
RETAIN FOR FUTURE REFERENCE
SAFETY: This fixture must be wired in accordance with the NATIONAL
ELECTRICAL CODE and applicable local codes and ordinances. A person
familiar with the construction and operation of the product and the hazards
involved must install this product. A qualified licensed electrician should
complete all work. Proper grounding is required for safety.
WARNING: Make certain power is OFF before installing or maintaining fixture.
RISK OF INJURY: Fixture may become damaged and/or unstable if not installed properly.
BUTTON PHOTOCONTROL INSTALLATION INSTRUCTIONS:
NOTE: Turn off electrical supply at the breaker. Follow all local electrical codes for wiring and grounding requirements
1. Remove threaded aperture
2. Insert photocontrol through opening (make sure o-ring gasket is on inside of fixture)
3. Prior to installing knurled nut apply small amount of silicone sealant around PC stem to ensure water tight connection
4. Securely tighten knurled nut
5. Ensure that the supply voltage matches the control
voltage rating
6. Wire control as indicated by control manufacturer
NOTE: Optional 0-10 V Dimming. Dimming provided through
grey & purple wires. Refer to control manufacturer for wiring
instructions.
240-145LSI Rev. 03/17
silicone sealant
Installation Questions?
Call LSI Field Service Department at:
1-800-436-7800 Ext. 3300
Fax: 1-877-861-1368
knurled nut
O-ring gasket
(on inside of xture)
©2017 LSI Industries Inc.
Publicidad
