LSI TSFL Serie Instrucciones De Instalación Y Montaje

INSTALLATION AND ASSEMBLY INSTRUCTIONS
TSFL | TMFL | TLFL Series
IMPORTANT: READ BEFORE REMOVING FIXTURE FROM
CARTON. RETAIN FOR FUTURE REFERENCE
SAFETY: This fixture must be wired in accordance with the
NATIONAL ELECTRICAL CODE and applicable local codes and
ordinances. A person familiar with the construction and operation
of the product and the hazards involved must install this product.
A qualified licensed electrician should complete all work. Proper
grounding is required for safety.
WARNING: Make certain power is OFF before installing or
maintaining fixture.
RISK OF INJURY: Fixture may become damaged and/or
unstable if not installed properly.
KNUCKLE MOUNTING (PFS SERIES & PFM SERIES)
MOUNTING - For floodlights supplied with a threaded knuckle mount to any metal 1/2" NPT mounting hole. Do not recess fixture.
AIMING - To adjust vertically, loosen aiming screw and tilt fixture in desired position. To adjust horizontally loosen swivel screw and
locknut. Aim as needed. Tighten swivel screw and locknut.
NOTE: Fixtures are not designed to be mounted upside down.
TRUNION MOUNTING (PFL SERIES & PFXL SERIES)
MOUNTING - For floodlights supplied with a trunion mount to any surface, with 5/16" bolts you provide. Make sure the fixture is
securely fastened.
AIMING - Remove small position-lock screw. Loosen adjustment bolt and adjust the fixture to the desired position. Tighten adjustment
bolts securely (10ft/lbs). Reinsert small position lock screw.
NOTE: Fixtures are not designed to be mounted upside down.
SLIPFITTER MOUNTING (PFL SERIES & PFXL SERIES)
MOUNTING - For floodlights supplied with a slipfitter, mount slipfitter over tenon (after wiring process). Securely tighten two set screws.
Slipfitter is designed to fit over 2 3/8" tenon or pipe.
AIMING - Remove side adjustment panel by removing locking screws. Loosen adjustment bolt and adjust the fixture to the desired
position. Tighten adjustment bolt. Replace side adjustment panel and replace screws.
NOTE: Fixtures are not designed to be mounted upside down.
WIRING
1. Turn off electrical supply at the breaker.
2. Follow all local electrical codes for wiring and grounding requirements.
3. Check to make sure that the supply voltage to the fixture is compatible with the fixture driver.
4. Connect the white fixture wire with white service wire.
5. Connect the black fixture wire to the black service wire.
6. Connect the green fixture wire to the ground wire.
7. Make sure all connections are secure using approved connecting devices.
NOTE: Optional 0-10 V Dimming. Dimming provided through grey & purple wires. Refer to control manufacturer for wiring instructions.
240-144LSI Rev. 05/17
Installation Questions?
Call LSI Field Service Department at:
1-800-436-7800 Ext. 3300
Fax: 1-877-861-1368
©2017 LSI Industries Inc.