Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND ASSEMBLY INSTRUCTIONS
TSFL | TMFL | TLFL Series
IMPORTANT: READ BEFORE REMOVING FIXTURE FROM
CARTON. RETAIN FOR FUTURE REFERENCE
SAFETY: This fixture must be wired in accordance with the
NATIONAL ELECTRICAL CODE and applicable local codes and
ordinances. A person familiar with the construction and operation
of the product and the hazards involved must install this product.
A qualified licensed electrician should complete all work. Proper
grounding is required for safety.
WARNING: Make certain power is OFF before installing or
maintaining fixture.
RISK OF INJURY: Fixture may become damaged and/or
unstable if not installed properly.
BUTTON PHOTOCONTROL INSTALLATION INSTRUCTIONS:
NOTE: Turn off electrical supply at the breaker. Follow all local
electrical codes for wiring and grounding requirements
1. Remove threaded aperture
2. Insert photocontrol through opening (make sure o-ring
gasket is on inside of fixture)
3. Prior to installing knurled nut apply small amount of silicone
sealant around PC stem to ensure water tight connection
4. Securely tighten knurled nut
5. Ensure that the supply voltage matches the control voltage
rating
6. Wire control as indicated by control manufacturer
240-144LSI Rev. 05/17
Installation Questions?
Call LSI Field Service Department at:
1-800-436-7800 Ext. 3300
Fax: 1-877-861-1368
silicone sealant
knurled nut
O-ring gasket
(on inside of xture)
©2017 LSI Industries Inc.
Publicidad
