ION TOTAL PA Glow Max Guia Del Usuario página 6

11. Clip LED: The Clip LED will flash red if the signal from the input jacks or Media Panel
audio source is clipping (distortion from an overly loud signal). If this happens,
decrease the setting of the Main Volume knob or the volume for the Aux/Mic Input (if
a loud device is plugged into either).
12. Light Mode Button: Press this button to toggle between one of these five modes for
the lights on the front panel.
•
Color Cycle: The lights slowly glow and cycle through colors. This is the default
mode when Total PA
button to freeze the lights on one color. Press and release the button to unfreeze.
•
Beat Sync: The lights flash and change colors according to the tempo of the music
playing on the speaker. For the best lighting effect, you may need to adjust the
volume of your device, the source volume, and/or the main volume.
•
Color Wheel: The lights rotate in a wheel of all colors.
•
Color Beat Sync: The lights rotate in a wheel of all colors and change direction and
speed according to the tempo of the music playing on the speaker. For the best
lighting effect, you may need to adjust the volume of your device, the source
volume, and/or the main volume.
•
Off: The lights turn off.
13. Power Cable Input (IEC): Insert the included power cable here to charge the unit.
14. Power Switch: Flip this switch to toggle the speaker's power on or off.
Note: Total PA
6
™
Glow Max is first powered on. Press and hold the light mode
™
Glow Max will power off after 15 minutes with no audio playing.