Getting Started And Operation - Blumfeldt Cosmic Beam Smart Manual Del Usuario

EN
24

GETTING STARTED AND OPERATION

• Take out the heater from the carton carefully. please save the carton for off-season
storage,
• Firmly fixed heaters according to the installation instructions,
• Do not use the same socket with other high-power appliance to avoid overloading.
Switch ON
• The power light flashes when heater is connected with power.
• Press  turn on the heater, screen show temperature of the room, if it lower than
preset temperature , the heater will be worked. Indicator light will blink.
Lock funktion
While the unit is in operation, first press the SWITCH button and then the button . The
key lock has been activated for all keys.
Display screen ON/OFF function
• When you press the DISPLAY button, the backlight goes off but the indicator light
remains on.
• When you press the DISPLAY button again, the backlight turns back on.
Temperature setting
• First press the SET button.
Then press the ∧ or ∨ buttons to increase or decrease the temperature by one
degree at a time. The maximum adjustable temperature is 45 °C and the minimum
adjustable temperature is 5 °C.
After you have set the temperature, the screen returns to the room temperature
display.
Timer
• When you press the SET button twice, "00" will flash on the screen. You can set the
time by pressing the ∧ or ∨ buttons.
• Each press of∧ or ∨ increases or decreases the time by one hour.
After you set the time, the machine automatically saves and returns to the original
display screen.
Open window detection
• If the room temperature falls by 3 °C or more within 2 minutes while the unit is in
operation, the unit stops heating, the screen flashes and a warning tone sounds.
Close the windows and restart the unit to resume heating operation.
WLAN reset
In the operating status, press "4", "3" and "2" in succession within 5 seconds to reset the
WLAN. This takes about 10 seconds.