EDM Product 08721 Manual De Instrucciones página 29

ASSEMBLY
ES
WARNING
Prior to assembly and adjustment always unplug the tool.
PT
Installing the Grinding Wheel
· Depress and hold down the spindle lock. To prevent damage to
spindle or spindle lock, always allow motor to come to a complete
EN
stop before engaging spindle lock.
· Remove the outer flange with spanner turning in anti-clockwise
direction. Do not remove the inner flange.
FR
· Make sure the slot on the inner flange is engaged with the square
neck of the spindle.
· Place the grinding wheel over the spindle with the depressed
center against the inner flange.
· Depress and hold down the spindle lock again, mount the outer
flange and securely tighten it with spanner provided clockwise.Do
not overtighten it.
Mounting the Auxiliary Handle
The tool has three screwed holes on top, left and right side of the
gear housing. Operators can choose any one of them to mount the
auxiliary handle depending on specific working condition and their
own habit.
Adjusting the Wheel Guard
This tool comes with a wheel guard. The guard must be fitted before
using the tool.
· Loosen the bolt on the collar of wheel guard with hex key.
· Align the protruding part inside the circular collar with the notch
on the front cap. Mount the collar fully onto the front cap.
· Turn the wheel guard to a desired angle after the collar is fully
inserted. Retighten the bolt to secure the wheel guard.
Instruction manual Ref. 08721