EDM Product 08721 Manual De Instrucciones página 30

OPERATION
This angle grinder is designed for the following purposes:
▶ Removal of casting burrs and finishing on various types of steel,
bronze, aluminum materials and castings.
▶ Beveling and finishing weld seams
▶ Grinding of welded sections cut by means of welding.
▶ Grinding of synthetic resin bricks, marbles etc.
▶ Cutting thin wall tubes and small size metal materials.
CAUTION
Never cover air vents. They must always be open for
proper motor cooling.
To start your grinder
▶ Plug the cordset into a power socket;
▶ Push the Lock-off Catch on the trigger switch forward;
▶ Pull on the trigger switch.
To stop your grinder
Release the on/off switch.
For Proper Operations
▶ Before starting the grinder, put on safety glasses and make sure
that the grinding wheel, guard and the tool are in good condition
and correctly fitted.
▶ Always hold the tool firmly with one hand on the rear handle and
the other on the side handle.
▶ Turn the angle grinder on and then apply the grinding wheel to
the workpiece.
▶ In general, keep the edge of the wheel at an angle of about 30°for
roughing and about 15 for finishing.
▶ Move the grinder back and forth or up and down over the work
area.
▶ Use just enough pressure to keep the grinder from chattering or
bouncing.
▶ Avoid overloading the tool for a long time, heavy pressure will
decrease its speed and put a strain on the motor .
▶ Lift the grinder away from the workpiece before turning your grin-
der off.
Instruction manual Ref. 08721
ES
PT
EN
FR