Technical Data - D+H ZA 35 Manual Original

Technical data

Type
Power supply
Nominal current
Nominal force
Nominal locking force
Service time
Duty cycle
Housing
Ingress protection
Temp. range
Fire stability
Nominal stroke length* ** See type plate
Additional functions **
* Adjustable with PLP 1
Normal operation =
SHEV- fast running =
Forces ZA 35 ZA 85
OPEN 300 N 800 N
CR III 300 N 800 N
CR II 300 N 800 N
CR I 300 N 800 N
Closing edge protection
In "CLOSE" direction the drive has an active
protection for the main closing edge. With an
overload in the closing range 3 and 2 the drive runs
"OPEN" for 10 seconds, then drive "CLOSE" again. If
after three attempts a closing is not possible, the
drive remains in this position.
In addition, the drive has a passive protection. The
closing speed in closure Range 2 and 1 is reduced to
5 mm/s.
Higher forces can occur on besides
closing edges. Danger of violent
pressure in handaccessible area.
6/16
ZA 35/85/105/155
ZA 35 (-HS)
24 VDC, ±15%
0,5 A (1,2 A)
300 N
1100 N
>10 000 double strokes
30 % (With cycle time 10 minutes)
A nodized aluminium / polycarbonate
IP 65
-5 ... +75°C
30 min / 300°C
/
Closing edge protection activated (3 stroke repeatings)
** Programmable with PLP 1 and PDA Servicetool
ZA 105 ZA 155
1000 N 1500 N
All forces
1000 N 1000 N
1000 N 1000 N + approx. 20 % switch-off reserve
800 N 800 N
(temporary)
ZA 85 (-HS) ZA 105 (-HS)
24 VDC, ±15% 24 VDC, ±15%
1,0 A (2,0 A) 1,2 A (2,2 A)
800 N 1000 N
Running speed and forces
Main closing edge
English
ZA 155 (-HS)
24 VDC, ±15%
1,4 A (2,5 A)
1500 N
99.824.29 1.2/03/12