Genergy Sleep Function; Synchronize New Remote Control Device - GENERGY TENERIFE 7500W Instrucciones De Uso

NOTE: Never, do not stop the automatic sequence of the starting or of the
shutdown. Only in case of an emergency. The automatic sequence has to be
completed, before to send a new signal from the remote control device.

7.3 GENERGY SLEEP function.

When we press ACTIVATE BATTERY button, the remote receiver waits for a
signal from the remote control device. This remote receiver has a small electric
consumption, which is supplied by the battery of the generator. The battery can
discharge if the generator remains during some time without run (standby
position).
To avoid the discharge of the battery, the generator has installed an automatic
disconnection system of the remote receiver. After 12 hours of the last running, the
receiver will be automatically disconnected.
Now, for a new start by remote control is necessary to reset the remote receiver.
On the control panel press the ACTIVATE BATTERY button.

7.4 Synchronize new remote control device.

1. On the control panel press MAIN SW switch to the ON position.
2. On the control panel keep pressed the RESET button (2 or 3 seconds) until
the PILOT LAMP flashes.
3. On the remote control device press any button. And on the generator, the
PILOT LAMP flashes 3 times and turns off. This means that the remote
control device has been synchronized correctly.
If you do not press any button of the remote control device within 5 seconds, the
PILOT LAMP indicator turns off and the synchronization process is not concluded.
51