Wolf 812308 Manual De Instrucciones página 2

rOOF MOUnT
For use with Models ICBPW3048, ICBPW3648, ICBPW448, ICBPW4848, ICBPW5448,
ICBPW6048, ICBPW6648, ICBPW3078, ICBPW3678, ICBPW478, ICBPW4878,
ICBPW5478, ICBPW6078, ICBPW6678,
ICBPL34, ICBPL46, ICBPL5
prepare the roof
15"
1¼" dia. hole
REMOVE SHINGLES
12 / "
11
16
Pilot Hole
(centered
between rafters)
9 /
13
16
From inside the attic space:
1
Drill a PiLOT HOLE up through the roof, centered between
rOOF raFTErS.
From outside - on the roof:
2
Measure and mark the 18" x 20½" rectangle. Cut and
remove only the shingles inside this rectangle.
3
Measure and mark the 11" DiaMETEr HOLE and the 1¼"
DiaMETEr HOLE. Cut these holes all the way through the
roof.
For flat roof installations:
4
Build a curb that will mount the blower at a minimum pitch of
2/12. Discharge end of the blower should be pointed away
from prevailing winds.
inSTaLLaTiOn
1"
11" dia.
hole
"
18"
2 "
install the Ventilator
5
Remove 10 COVEr SCrEwS and lift off ventilator cover.
6
Remove roofing nails from top 2/3 of shingles around cut-
out area.
7
Feed the electric power cable (supplied with ventilator)
through the 1¼" DiaMETEr HOLE in roof.
8
Slide ventilator's FLaSHing SHEET up and under loosened
shingles until ventilator's discharge collar fits into 11"
diameter hole.
9
Use 6 screws (provided) to attach ventilator to roof. DriLL
6 MOUnTing HOLES inside ventilator, as necessary.
10
Seal screw heads, loosened shingles, and edges of
flashing sheet with a good grade of roofing cement.
11
Check for free movement of spring-loaded damper and
re-install ventilator cover.
20½"
10 Cover 10 Cover
Screws Screws
Flashing
Sheet
attach power cords to hood
12
The ventilator is prewired with 12 feet of H05VV-F
7 "
3G1 power cable. Run ventilator cable to range hood's
electrical wiring box.
13
Secure cable to range hood with a strain relief (included
in parts bag). Make wiring connections per instructions
provided with your Wolf range hood.
14
Install the separate power cord and strain relief (included
in parts bag) to the range hood. Refer to instructions
provided with your Wolf range hood.
15
Turn on power and check for proper operation of
ventilator.
MODEL 812308
Damper
Bird Screen
OUTSIDE - ROOF VIEW OUTSIDE - ROOF VIEW
Page 
Drill 6
Mounting
Holes
Remove
roofing
nails from
top 2/3 of
shingles.