Wall Mount - Wolf 812308 Manual De Instrucciones

waLL MOUnT

For use with Models ICBPW3048, ICBPW3648, ICBPW448, ICBPW4848, ICBPW5448,
ICBPW6048, ICBPW6648, ICBPW3078, ICBPW3678, ICBPW478, ICBPW4878,
ICBPW5478, ICBPW6078, ICBPW6678,
ICBPL34, ICBPL46, ICBPL5
prepare the wall
17"
1¼" dia. hole
Pilot Hole
(centered between studs)
14 / "
11
16
REMOVE
SIDING
11 / "
13
16
From inside the wall:
1
Drill a PiLOT HOLE through the wall, centered between
waLL STUDS.
From outside - on the wall:
2
Measure and mark the 22" x 29½" rectangle. Cut and
remove only the siding inside this rectangle.
3
Measure and mark the 11" DiaMETEr HOLE and the 1¼"
DiaMETEr HOLE. Cut these holes all the way through the
wall.
inSTaLLaTiOn
3"
11" dia.
hole
22"
install the Ventilator
4
Remove 10 COVEr SCrEwS and lift off ventilator cover.
5
Feed the electric power cable (supplied with ventilator)
through the 1¼" DiaMETEr HOLE in wall.
6
Position ventilator on wall so its discharge collar fits into 11"
diameter hole.
7
Use 6 screws (provided) to attach ventilator to wall. DriLL
6 MOUnTing HOLES inside ventilator, as necessary.
8
Seal screw heads and edges of flashing sheet with a good
grade of roofing cement or other sealant.
9
Check for free movement of spring-loaded damper and
re-install ventilator cover.
29½"
10 Cover 10 Cover
Screws Screws
Flashing
Sheet
attach power cords to hood
10
The ventilator is prewired with 12 feet of H05VV-F
3G1 power cable. Run ventilator cable to range hood's
electrical wiring box.
11
Secure cable to range hood with a strain relief (included
in parts bag). Make wiring connections per instructions
provided with your Wolf range hood.
12
Install the separate power cord and strain relief (included
in parts bag) to the range hood. Refer to instructions
provided with your Wolf range hood.
13
Turn on power and check for proper operation of
ventilator.
MODEL 812308
Damper
Bird Screen
OUTSIDE - ROOF VIEW OUTSIDE - WALL VIEW
Page 3
Drill 6
Mounting
Holes