Hubbell Qualtech QCS3000 Guia De Inicio Rapido

Enclosures are shipped assembled except for attaching monitor hood to monitor enclosure wrapper, snapping monitor enclosure
wrapper to CPU enclosure or base, removing plastic film from acrylic face plate, and cutting cable grommet to fit CPU and/or moni-
tor power cords.
Attaching Monitor Enclosure Wrapper
Ball studs and clips are provided for ease of attaching or removing monitor enclosure
wrapper. To attach wrapper, simply position clips over ball studs (Fig. 1) and snap in
place. Press down on each corner to engage the seal. When removing wrapper, 18
lbs. of pressure is required to release the clips. Apply pressure in the upper corners
of the enclosure wrapper. Threaded holes are provided in the center flanges of the
wrapper for slotted screws (included) if further security is required.
Attaching Monitor Hood to Wrapper
Remove screws holding the acrylic face plate. Tear off clear plastic film on both sides.
Mount monitor hood on the outside of the face plate and replace the screws (Fig. 2).
Monitor Wrapper
Figure 2–Attaching Hood
6. Slip cables through grommet to the drilled holes and replace the grommet in the
holder, compressing it around the cables.
7. Reattach the holder onto the back panel.
Installing Surge Suppressor
Multiple outlet surge suppressors are shipped loose to allow individual placement by end user. Double-sided tape has been applied
to back of surge suppressor for application convenience. Remove plastic cover and apply suppressor where appropriate.
Grounding
Green ground screws are located on the back of each unit.
Please See Special Instructions for Individual Models on Opposite Side
Fan and Filter Maintenance
Filters should be checked and cleaned with soap and water or replaced on a scheduled basis depending on shop environment.
Replacement filters are available from Hubbell Workplace Solutions.
Assembly and Use Instructions
Monitor, CPU and Printer Enclosures
Cutting Cable Grommet and Installing Cables
Face Plate
1. Remove cable grommet holder from back panel (refer to Figure 3).
Hood
2. Remove neoprene grommet from the holder.
3. Drill a hole for each cable using a drill
slightly smaller than cable. Holes
should be in center of grommet,
approximately 1/2" apart. Make sure
holes are positioned so grommet
holder will not interfere with cables.
4. Using a sharp knife or hacksaw, make
a cut from each hole to the outside of
Screws
the grommet.
5. After placement of electronics inside
enclosure, string through opening in
back panel to outside.
Base or CPU Enclosure
Figure 1–Attaching Wrapper
Neoprene
Grommet
Grommet Holder
Figure 3–Cable Grommet
Monitor Wrapper
Ball
Studs
Opening in
Back Panel
Holes and Slits
in Grommet