Crosley XSS23G Manual Del Propietario E Instrucciones De Instalación página 12

Automatic Icemaker
Accessing Ice and Reaching the Power Switch on Dispenser Models
There are two types of ice storage bins on dispenser
models. One has a shelf above the bin, the other does
not .
Special note for models with tilt-out ice bin:
■ T hese models have a tilt-out ice bin. The bin can be
tilted out as shown in the illustrations, and it will hold
itself up while you take ice out or turn the icemaker
power switch on and off . Be sure to put the bin back in
place before closing the door .
NOTE: In order to take full advantage of the tilt-out ice
bin, only store items on the shelf below the ice bin that
are no taller than the lowest point on the bin .
Models with tilt out ice bin
To access ice and reach the icemaker power switch:
1. Lift the bin, then pull it forward until the bin stops .
2. Lower the bin to access ice or reach the power switch .
Removing Ice Bin
CAUTION
The ice bin is heavy when full.
Set the power switch to the OFF position before
removing the bin .
When replacing the bin, be sure to press it firmly into
place . If it does not go all the way back, remove it and
rotate the drive mechanism 1/4 turn . Then push the bin
back again .
12
(dispenser models)
Models with a shelf above the ice bin
To access ice, pull the bin forward .
Shelf
Ice Bin
To reach the power switch, pull the shelf straight out .
Always be sure to replace the shelf .
Shelf
On some models, to access ice or reach the power
switch:
1. Pull the bin forward until the bin stops .
2. Lower the bin to access ice or reach the power switch .
Rotate
Drive
Mechanism
Dispenser Models only
49-1000105 Rev. 0