Kohler K-2298 Guía De Instalación Y Cuidado página 8

Installation
1
Verify cabinet
clearance.
Vérifier le
dégagement
du meuble.
Verifique el
espacio libre
del gabinete.
3
Silicone Sealant
Joint en silicone
Sellador de silicona
Under-Mount Installation
Install the water supplies and drain piping according to the roughing-in
information.
Verify cabinet clearance beneath the countertop for the sink basin, faucet valving,
and drain piping.
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation instructions.
Clean the underside of the countertop and the sink rim.
Loosely install the clips to the underside of the countertop.
Apply a generous bead of silicone sealant to the top surface of the sink rim where
it will contact the countertop.
Position the sink under the cutout.
NOTICE: Risk of product damage. Do not overtighten the clamps. Overtightening
may cause irreparable damage to the bathroom sink.
Hold the sink in place and rotate each clip over the rim. Evenly tighten the clips
to secure. Do not overtighten.
Immediately wipe away excess sealant and fill voids as needed. Allow the sealant
to set for 30 minutes before proceeding.
Complete the faucet and drain installations.
Run water into the bathroom sink and check for leaks.
1201382-2-A
2
Loosely install the clips.
Installer les brides sans serrer.
Instale sin apretar los clips.
4
8 Kohler Co.