Rear Panel Overview - Teac AV-H500 Manual Del Usuario

Rear Panel Overview

1
1AUDIO signal jacks
O TUNER input jacks
Connect the output (LINE OUT) jacks of
the tuner (T-H500) to these jacks.
O MD/TAPE (REC/PLAY) jacks
These jacks are used for the connection
of an MD deck or tape deck.
Connect the output (LINE OUT) jacks of
the MD deck or tape deck to the PLAY
jacks, and the input (LINE IN) jacks of
the MD deck or tape deck to the REC
jacks.
O AUX input jacks
These jacks accept an auxiliary source
such as an LD player or an additional
tape deck.
OLD/CD input jacks
Connect the output (LINE OUT) jacks of
the CD player (PD-H500) to these jacks.
O VCR OUT/IN jacks
Connect the output (AUDIO OUT) jacks
of the video deck to the IN jacks, and the
input (AUDIO IN) jacks of the video deck
to the OUT jacks
Note:
Make sure that you connect the white
pin-plug to the white jacks (left) and the
red pin-plug to the red jacks (right).
2 3
–
2SUB WOOFER OUT jack
Connect the SUB WOOFER OUT jack to a
dedicated amplifier for better reproduction
of the low-frequency region.
3VIDEO signal jacks
Connect the MONITOR OUT jack to the TV
set. Connect the IN and OUT jacks to a VCR,
LD or other component system.
4MD/TAPE selector switch
Set to either MD or TAPE when you connect
a source unit to the MD/TAPE jacks.
5REMOTE CONTROL jacks
These jacks are used for the connection of
the TEAC Mini component system (T-H500,
R-H500, PD-H500) for the purpose of
operating it using the Remote Control unit
(RC-646 provided with the amplifier) or
system control signals.
6Speaker terminals (see page 3.)
– 5 –
4 5 6
–
–
–
7AC power cord
Plug the AC power cord into an AC wall
socket.
8Main power switch
Press the ON side of this rocker (seesaw)
switch to turn the power ON (standby
position); press the OFF side to turn the
power off.
Note:
Leave the main power switch ON at all
times.
7 8
–