EDM Product 07181 Manual Del Usuario página 18

How to use:
1 · Control panel
- LED display
- ON/OFF button
- M button
- Up/down button
- Timer button
- C (cancel button)
2 · Display instruction
Temperature Data
Heating symbol
3 · Remote control:
- On/Off button
- C (cancel) button
- ECO button
- SET button
- OK button
- EDIT (ED) button
- Timer button
- TEMP (temperature) button
- Timer on / Timer off button
- Higher (+) button
- Lower (-) button
- WEEK button
· Operation using the control panel on the item:
Make sure the item is attached to the wall firmly. Turn the main switch ON.
1- Press the ON/OFF button on the control panel:
In on mode, first the item's display shows the set temperature (the set temperature is the most recently set
temperature or 45°C in case of first use.) For 3 seconds and subsequently, the ambient temperature (If
ambient temperature is lower than 0°, temperature data will shows "LO").
In off mode, only capacity indication symbol appear.
2- In on mode, press + and - button, the set temperature can be adjusted from 40°C to 70°C (circulatory).
If the set temperature is higher than the ambient temperature, the item will start to heat and the heating
symbol will appear.
When the set temperature is reached, the item will automatically switch OFF and will switch ON again
when the room cools down.
The heating symbol will disappear and re-appear accordingly.
In the heating state, the thermistor only controls the max. temperature 70°C.When the temperature
reaches this level,the thermistor will automatically turns off the heating. The default temperature is 45°C.
Once the temperature is detected to be over 80°C, the heating will stop automatically and alarm will be
given. At the same time when the open or short circuit,which means the thermistor is out of action, turn the
item off immediately and unplug. Contact a servicing point to have the item repaired.
3- Timer function, with 7hours timer function. If there are both weekly timer and 7 hours timer, weekly timer
is preferred.
4- Press ECO button to start ECO function, the temperature setting is 45°C.
5- Checking the day/time data on the heater:
The heating panel should be ON and should heat. Therefore, the heating symbol is visible on the display. (Do
this by setting the temperature higher than the ambient temperature, for example.)
Press M (on remote control press SET) button to check the day and timer: HH = day of the week, H1=hour
and H2 = minute.
Attention: If the item is switched off using the main switch or by removing the plug from the socket,the day
will be re-set to 1 and the time to 00.00 the next time you switch the item ON again.
Capacity indication symbol