Connections - Axxess AXTO-NI1 Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an AXSWC (sold separately), there will be an accessory wire on the AXTO-
NI1 harness to connect as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• Tape off and disregard the following (13) wires, they will not be used in this application:
Blue/Pink, Blue/White, Brown, Gray, Gray/Black, Green, Green/Black, Green/Purple,
Purple, Purple/Black, Light Green, White, White/Black
From the AXTO-NI1 harness to the aftermarket radio:
• Connect the Black wire with a ring terminal to chassis ground.
• Connect the Yellow wire to the battery wire.
• If installing an AXSWC (sold separately), connect the Red wire to the accessory wire.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
2

CONNECTIONS

The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
Note: Before connecting this wire, also refer to the "AXCSD-6V 12-volt to 6-volt" converter section .
• Connect the Light Green wire to the parking brake wire.
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks to the AUX input.
• If retaining the factory backup camera, connect the Yellow RCA jack to the reverse camera
input. Please reference "Reverse camera operation" on page 4 if retaining the camera.
12-pin AXSWC harness & 3.5mm jack:
• This 12-pin AXSWC harness & 3.5mm jack are to be used with an AXSWC (sold separately)
to retain steering wheel audio controls. If the AXSWC is not being used, disregard this
harness and 3.5mm jack. If it is to be used, please refer to the AXSWC instructions for radio
connections and programming. Disregard the harness that comes with the AXSWC.
AXCSD-6V 12-volt to 6-volt converter:
• Connect the Black wire to chassis ground.
• Connect the Blue/Red wire to the Red wire labeled "Camera Power 6V".
• Connect the Blue/White wire to the Green/Purple wire.
Note: The Green/Purple wire will connect to both the AXCSD-6V, and the aftermarket radio.