Error Codes; Special Messages - Taurus DARKFIRE DAILY Manual Del Usuario

TIMER FUNCTION
- In order to use the timer, push the timer button.
- The LED display will show 30 minutes. Use the
buttons +/- to change the time.
- Once selected, wait for 5 seconds until the
timer is activated automatically.
- Once the time has run out, the appliance will
stop working and it will go to StandBy
ONCE YOU HAVE FINISHED USING THE
APPLIANCE
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
- Clean the appliance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- It is advisable to clean the appliance regularly
and remove any food remains.

SPECIAL MESSAGES

ERROR CODES

The screen can show different Error codes.
E0 → The accessory you are using is not
detected.
E1 → Don't reach minimum voltage
E2 → Too much Voltage for the plate.
E3 → Thermostat open
E4 → Thermostat broke
E5 → PCB Thermostat open
E6 → PCB Thermostat Broken
E7 → Interior temperature detection system
broke.
E8 → Internal error not determined.
E9 → Overheating.
For E0, check if the accessory for cooking is
induction compatible.
Fore E1 – E9, take the appliance to the closest
Technical assistance Service.