Troubleshooting - I-Tech Mio-Sonic Manual De Uso

pressure
Inside the supplied carrying bag
temperature
relative humidity
pressure

Troubleshooting

Any type of work on MIO-SONIC must be carried out exclusively by the
manufacturer or by an authorized dealer. In any event, any presumed
malfunction of MIO-SONIC must be verified before sending the device to the
manufacturer.
Check the following:
PROBLEM
POWER LED fails to
light up
Il LED d'accensione
funziona
correttamente
non viene erogato
alcun output
Some comands don't
work regularly.
The device works
properly, but there is
a noticeable drop in
the effectiveness of
the treatment.
IACER Srl
from 800 to 1060hPa
from –10 to +50 °C
from 20 to 93%
from 700 to 1060hPa
POSSIBLE CAUSE
The plug of the adaptor is
not inserted
socket properly.
Network
correctly inserted in the
registered connector.
Network cable worn out
and interrupted.
Power swith non set to
ON.
Time and intensity not set
ma
correctly.
Defective
buttons.
Failure electronic control
circuit.
Possible head failure.
Possible failure of the
device current generator
circuit.
Check
into the
operation.
cable not Insert the plug and
cable correctly into the
device connector.
Replace the network
cable.
Check that the switch
has been ON.
Check and reset the
desired values.
keys and
Contact
manufacturer
Contact
manufacturer
47
SOLUTION
the socket
the
the
MNPG71-04