Viking DrawerMicro Instrucciones De Instalación página 3

ANTI-TIP BLOCK
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION INSTRUCTIONS
To reduce the risk of tipping of the drawer, the Anti-Tip
block must be properly installed located 14
the floor on which the appliance will sit. The 6" Anti-Tip
block must be provided by the installer. See FIGURE 1.
The Anti-Tip block prevents serious injury that might result
from spilled hot liquids.
If the DrawerMicro Oven is ever moved to a different
location, the Anti-Tip block must also be moved and
installed. When installed to the wall, make sure that the
screws completely penetrate the dry wall and are secured
in wood or metal so that the block is totally stable. When
fastening, be sure that the screws do not penetrate
electrical wiring or plumbing.
ELECTRICAL OUTLET
The electrical requirements are a 120 volt 60 Hz, AC
only, 15 amp. or more protected electrical supply. It is
recommended that a separate circuit serving only this
appliance be provided.
The appliance is equipped with a 3-prong grounding plug.
It must be plugged into a wall receptacle that is properly
installed and grounded. Should you only have a 2-prong
outlet, have a qualified electrician install a correct wall
receptacle.
Note:
If you have any questions about the grounding or electrical
instructions, consult a qualified electrician or service
person.
DRAWER INSTALLATION
1. Place the DrawerMicro Oven adjacent to the wall or
cabinet opening. Plug the power supply cord into the
electrical outlet.
2. Carefully guide the appliance into the prepared
opening. Avoid pinching the cord between the oven
and the wall.
3. Slide the drawer all the way until the mounting flange
is flush with the face of the cabinet. See FIGURE 5A.
4. Open the drawer. Using the 4 holes on the drawer as
a template, pre drill the cabinet using a
FIGURE 5A.
5. Secure the drawer with the 4 screws supplied. See
FIGURE 5B.
Electrical Outlet
Location
/ " above
13
16
4"
(101.6 mm)
1 / " bit. See
16
5"
(127 mm)
FIGURE 3
Electrical Outlet
Location
FIGURE 4
FIGURE 5A
FIGURE 5B
E3
6"
(153 mm)
5"
(127 mm)
4"
(101.6 mm)
Mounting
Flange
PARTS SUPPLIED
4 Screws
Anti-tip
Block