Test Printing - Epson TM-H6000IV Manual Del Usuario

English
2. Open the roll paper cover using the tabs on both sides of the roll paper cover.
3. Remove the used roll paper core, if there is one, and insert the roll paper in
the correct direction.
4. Pull out some paper, and close the roll paper cover.
5. Tear off the paper with the manual cutter.
Inserting Slip Paper
When printing on slip paper, follow the steps below to insert the paper. (See
illustration L.)
If your printer is equipped with a MICR reader, MICR reading is available by
inserting the check paper so that the MICR characters on the paper are on the right
side.
1. Turn on the printer.
2. Insert the paper face up with the right paper edge against the right side of the
paper guide, and insert it as far as it will go.
3. Insert the paper straight until the top edge of the paper touches the stopper.
4. When the printer starts feeding the paper, release it immediately.
5. Pull the ejected paper straight up out of the printer.
Inserting Validation Paper
If your printer is a validation model, insert the paper in the same way as normal slip
paper (See "Inserting Slip Paper.") or follow the steps below. (See illustration M.)
1. Turn on the printer.
2. Insert the paper with the right paper edge against the right side of the paper
guide at the printer top, and insert it as far as it will go.
3. Insert the paper straight down until the bottom edge of the paper touches the
stopper.
4. When the printer starts feeding the paper, release it immediately.
5. Pull the ejected paper straight up out of the printer.

Test Printing

After the printer setup or when the printer is not operating correctly, you can
check the printer operation with test printing. If the printer performs pattern
printing following the steps below, the printer is operating normally.
Test Printing on Roll Paper
Make sure all the covers are closed, and while pressing the Feed button, turn on
the printer. After the printer prints its status and the Paper LED flashes, press the
Feed button again to restart the test printing.
Test Printing on Slip Paper
Make sure all the covers are closed, and while pressing the Release button, turn
on the printer. After the Slip LED flashes, insert the slip paper. If your printer is
equipped with the endorsement printer, the printer prints both sides of the paper.
Both types of test printing are completed when "*** completed***" is printed.
12 TM-H6000IV User's Manual