Connecting Fixtures In Series For External Control - Lumatek ZEUS 1000W XTREME PPFD CO2 Manual De Instrucciones

6.6 Connecting the manual dimmer or external lighting controller
The dimmer control or lighting controller is connected to the Signal IN connector on the fixture.
This enables light intensity (PPF output) to be adjusted according to requirement. The LED fixture light intensity
can be adjusted without changing spectral power distribution or losing efficiency.

6.7 Connecting fixtures in series for external control

For detailed instructions please refer to the Lumatek Control Panel manual.
Position and hang each fixture appropriately. Zeus series fixtures use 0-10V signal protocol for control.
Connect controller output signal wire to
fixture 1 SIGNAL IN connector. Connect
signal wire from fixture 1 SIGNAL OUT
connector to fixture 2 SIGNAL IN connector.
Continue to connect fixtures in series for up
to 100 fixtures per controller see Fig.
Connect manual dimmer
cable or lighting controller
cable to SIGNAL IN port.