Module Installation - Urmet Yokis MFP6ARP Manual Del Usuario

WIRELESS MODULE FOR ELECTRIC HEATING WITH PILOT WIRE
MFP6arP 5454498 Wireless module for electric heating with
all YOKIS receivers are compatible with
YOKIS transmitters
(remote controls, wall-mounted remote controls,
flush-mounted transmitters).
Technical Specifications:
Mains voltage:
Module consumption:
Ambient temperature:
Relative humidity:
Dimension:
Wiring:
Nominal output capacity:
Action type:
Pollution degree:
Isolation voltage:
Resistance of plastic to incandescent:
Installing Cautions
In order to follow the safety rules, the module must be connected to a power line that is upstream protected by
a magnetothermic switch 10A C curve.
WIRING
Electric
radiator 2
The connections must be made
using the same live/neutral pair

MOdULe INSTaLLaTION

Remove the cover.
Secure the module by means of screws and wall anchors supplied in the kit.
By means of a slotted screwdriver, press the terminals and insert the wires.
Pierce the cover at the wire passage.
Reposition the cover.
DS1054-050B
pilot wire
230V +/- 15% - 50Hz
<1VA - <0.3W
from -10°C to +50°C
from 0 to 70%
50 x 135 x 30 mm
Maximum section of cables: 2mm
10 radiators or 150mA /230Vac
1.Y
2
2500V
from 75°C to 125°C
Electric
radiator 1
rear VIeW
REAR
MFP6arP configured in Standard mode
radIO raNGe:
POWer range:
• Inside 100 m² apartments with perpendicular
crossing of main wall or ceiling.
• 250m open range.
(Note: in both cases the range may be reduced
by the presence of metallic elements, crossing
of walls, or partitions).
radIO TraNSMISSION:
The transmitter Led will light up only if the
radio transmission was successful.
2
Adding an intermediate receiver will solve the
problem of an insufficient range.
Refer to the transmitter instruction booklet for
more information.
Optional
remote
button
P9
GB
Module button
Comfort (red LED)
Comfort-1 (green)
Comfort-2 (blue)
ECO (red)
Antifreeze (red)
Stop and wireless
communication (red)
"Connect" button
(under cover)
FrONT VIeW
FRONT