GET HOUR METER Guia página 5

4.
Install the device applying
the double sided tape at a
temperature greater
10°C / 50°F.
WARNING:
•
We recommend securing
the device with cable ties,
which can be inserted into the
slots on the outer case.
•
Keep the device away from
places where the temperature
exceeds 70°C / 158°F (e.g. the
exhaust pipe).
5.
Start the engine. The device
will automatically start after
about 8 seconds. The hourglass
icon on the left side of the display
will blink when the device has
started counting.
Hourglass icon
Decimal point, separating hours
and tens of minutes
6.
With the engine turned off,
using the multi-function button
allows the following actions:
than
View Total Counter:
Press the multi-function button
once. The display will show "tot"
for about 3 seconds. Afterward,
it will display the total counter for
about 8 seconds.
View Partial Counter:
While viewing the total counter,
press the multi-function button
once more. The display will
show "Par" for about 3 seconds.
Afterward, it will show the partial
counter for about 8 seconds.
Reset Partial Counter:
While viewing the partial counter,
press and hold the multi-function
button until the display shows
5
4 blinking dashes, then release.
After a few seconds, the display
will turn off. The partial counter
will then be reset.
Activate Lock Mode:
Press the multi-function button
once. When the display shows
"tot", press and hold the multi-
function button for about 8
seconds. The display will show
"Loc" and counting will be
stopped. To turn Lock Mode off
and resume counting, simply
press the multi-function button
once more.
Adjust Sensitivity:
Press the multi-function button
3 times. The display will show
"Sen", followed by the current
sensitivity level. This will be either
"Hi" (high sensitivity) or "Lo" (low
sensitivity). To switch between
the two levels, press the multi-
function button. After a few
seconds, the display will turn off
and the selected sensitivity level
will be active.
EN