NORTH STATES 5150 Instrucciones página 3

Installation
Step 1
Measure width of the opening.
Step 2
Insert latch spindles into upper and lower
holes on the end of one gate frame, and
hinge spindles into the other gate frame.
Step 3
Set the appropriate width of the gate by overlapping the two
frames to the extent necessary to allow room for the hinge and
latch spindles. The minimum allowable overlap is two bars. The
maximum allowable overlap is seven bars.
Note: The upper and lower latch and hinge spindles are adjustable to
accommodate the gap between the gate frame and the opening.
Step 4
Secure the gate frames together
by connecting the upper and
lower assembly fittings to both
the top and bottom of the gate
frames.
Step 5
Note: Do not mount hardware into sheetrock or plaster. Hardware is
included for use in solid materials only such as wood or metal.
Use the template provided to mark the
screw hole positions on the surface to which
the hinge side of the gate will be mounted.
a. On the upper hinge holder press the
release button to remove the cover and
secure the hinge holder with the screws
provided. Note: do not put the cover
back on at this time.
b. Secure the lower hinge holder with the
screws provided.
62.3cm - 102.9cm
24.5" - 40.55"
Page 3
CLICK!