NORTH STATES 5150 Instrucciones página 4

When using the gate at the top of
!
the stairs, never allow the gate to
swing over the stairs.
Step 6
Use the template provided to mark the screw hole positions on the
surface to which the latch side of the gate will be mounted.
a. Determine the direction you would like the gate to swing.
Note: Both the upper & lower gate stops have a raised edge. The raised
edge should be installed on the side to which you do not want the gate to
open. If you are not using this at the top of the stairs and would like the
gate to swing in both directions, install both the upper and lower latches
without the gate stops.
b. Secure the lower latch with gate stop with the screws provided.
c. Press down on the upper latch to insert the top screw when
securing the upper latch with gate stop.
Step 7
Insert the upper and
lower hinge spindles
into the upper and
lower hinge holders.
a. Secure the upper
hinge spindle by
clicking the
cover back on
the upper hinge.
Step 8
Adjust the protrusion of the hinge
and latch side spindles by turning
them so that the distance between
the gate frame and the opening is
no more than 2.25". Secure the
locknut with the wrench provided.
The upper and lower latch spindles
must be engaged in the latches.
< 60mm
< 2.25"
CLICK!
< 60mm
< 2.25"
Page 4