Product Ratings - Akron STYLE 5150 MERCURYMASTER 1000 GPM NOZZLE Instrucciones De Operación

The following is intended to provide the basic instructions for operating a MercuryMaster 1000 nozzle . Read and understand these
operating instructions before use .

PRODUCT RATINGS

Flow: Style 5150 MercuryMaster Nozzle 350 - 1000 GPM at 75 psi
Maximum Pressure: 200 psi/14 bar
PRODUCT WARNINGS
WARNING: Charge all lines slowly to facilitate a controlled water pressure build-up during start-up . Open and close slowly . R apid
opening will produce a sudden thrust . Rapid opening and closing can cause water hammer . Have your monitor
properly supported to control the reaction force created by the stream .
WARNING: At pressures below that indicated on the label, the nozzle will have reduced flow and reach . Be sure you have enough
flow and pressure for the situation (See IFSTA and NFPA manuals for guidelines) .
WARNING: Ensure the nozzle is aimed in a direction that is safe, prior to flowing .
WARNING: Do not use the nozzle as a forcible entry tool . Doing so may damage it or make it inoperable .
WARNING: Ensure the thread on the nozzle swivel is matched to the thread on the monitor .
PRODUCT CAUTIONS
CAUTION: If any tags or bands on the nozzle are worn or damaged and cannot be easily read, they should be replaced .
CAUTION: For use with fresh water or standard fire fighting foams only . Not recommended for use with salt water . After use
with foam or salt water, flush with fresh water .
CAUTION: For firefighting use only .
CAUTION: Do not over tighten the nozzle onto the hose connection .
CAUTION: The nozzle is configured for optimum performance . Do not alter in any manner .
CAUTION: Do not expose the pattern control ring to Trichlorethylene or Trichlorethane . These chemicals can weaken the parts
and make the nozzle inoperable over time .
CAUTION: Your nozzle should be inspected prior and after each use, to ensure it is in good operating condition . Periodically, an
unanticipated incident may occur where the nozzle is used in a manner that is inconsistent with standard operating
practices and those listed in IFSTA . A partial list of potential misuses follows:
• Operating above maximum rated pressure and flow.
• Not draining, and allowing water to freeze inside the nozzle.
• Dropping the nozzle from a height where damage is incurred.
• Prolonged exposure to temperatures above +130 degrees F, or below -25 degrees F,
• Operating in a corrosive environment.
• Other misuse that might be unique to your specific fire fighting environment.
STYLE 5150 MERCURYMASTER 1000 GPM NOZZLE
OPERATING INSTRUCTIONS
120389