Installing A Micro-Sd Card - Swann HD PENCAM Manual De Instrucciones

Turning the PenCam On
• Press the power/record button (on top off the pen) and hold until the both the
orange and blue lights turn on then release it. When the camera is ready to use
the orange standby light will stay on and the blue light will turn off .
• The orange light will blink when it is on standby in picture mode or stay lit when
it is on standby in video mode.
Turning the PenCam Off
• With the PenCam on standby press and hold the power/record button until the
orange light turns off .
• The PenCam will not switch off if you do this while the PenCam is in Video mode
and recording.
• If the PenCam is recording you must press the button once to stop recording and
return to standby (static orange light) then press and hold the button until the
orange light turns off .
Switching between Video and Picture
To switch between Video and Picture mode,
unscrew the PenCam to reveal the USB
connector. Using the tip of a pen or fi ngernail,
move the selection switch (pictured) to 1 for
PICTURE or 2 for VIDEO.

Installing a micro-SD card

The PenCam stores the VIDEO and PICTURES to standard micro-SD fl ash cards.
To insert a micro-SD card, separate the two parts of the pen to reveal the USB port.
The micro-SD port is on the other side of the USB port.
Slide the card into the slot making sure the gold contacts on the micro-SD card are
face down. Push the card gently into the slot until you feel some resistance. DO NOT
force the card in as this may damage your card and the PenCam.
To remove the card, slide the micro-SD card out using a fi ngernail as leverage against
the notch on the top edge of the micro-SD card.
Insert the micro-SD card as
shown into the slot until you
feel some slight resistance
Operating the Pencam
Introduction
Video
mode
rd.
Picture
mode
3