Operation - Klarstein 10031938 Manual De Instrucciones

OPERATION

1 Put the clean food in the trays. – Do not overload the trays and never overlap the
food. Close the cover.
Note: Always start to load the food from the bottom tray to the top tray.
2 Plug dehydrator into wall outlet. There is a beep sound at the beginning when it
starts up. The LED screen will show default time setting "10:00" and temp setting
"70 ". When it gets into standby mode, the signal ":" between time value does not
flash.
3 Product in the standby mode, press the "TIMER" button and LED screen shows the
time value. According to actual needs, press "+" or „-" button to change the drying
time between „0:30" and "19:30". Press „+" or „-" button once, the time increment
or decrement is 30 minute/press. If press „+" or „-" button for long time, then it
automatically increases or decreases. 3 seconds after finish setting the drying time,
system automatically gets into standby mode in current time setup.
4 Product in the standby mode, press the "TEMP" button and LED screen shows
the temp value. According to actual needs, press „+" or „-" button to change the
drying temp between „35 " and "70 ". Press „+" or „-" button once, the temp
increment or decrement is 5 /press. If press „+" or „-" button for long time, then it
automatically increases or decreases. 3 seconds after finish setting the drying temp
system automatically confirms to work in current temp setup. LED screen standby in
time mode.
Note: Set low temperature for thin/small pieces of food or for a small load of food.
Set high temperature for drying thick/big pieces of food and large loads. The
thermostat can also be used to decrease the temperature as the food is near the end
of its drying cycle making it easier to control the final moisture level in the food.
5 After setting time and temp, press "Start/Reset" button, motor and fan start first,
then heating element start working 5 seconds later. Set time begins to count down,
the signal ":" on LED screen flashes.
EN
15